Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27M0U _51 Engine / Hybrid System _049139 CRUISE CONTROL _0234343 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM detects a cruise control switch signal and sends it to the combination meter via CAN. Then the cruise control indicator light comes on.

·

The cruise control indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
a.

Using the Techstream, perform the Active Test (see page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator light operation OFF or ON -

OK:

Indicator light comes on / goes off.




OK

2.READ VALUE USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)

NG

2.READ VALUE USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
a.

Using the Techstream, read the Data List (see page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Indicator M-CPU Cruise control indicator light (Main CPU) / ON or OFF ON: Cruise control indicator light is ON
OFF: Cruise control indicator light is OFF
-

OK:

When cruise control main switch operation is performed, the result will be same as above.


Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 3UR-FE) C
NG (for 3UR-FBE) D



A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

B

C

D