Home › Engine / Hybrid System › 1UR-FE STARTING › STARTER(for 2.0 kW Type)
RM27M0U _51 Engine / Hybrid System _049144 1UR-FE STARTING _0234363 STARTER(for 2.0 kW Type) A

1UR-FE STARTING  STARTER(for 2.0 kW Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17104 3.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

Hide 28192 4.REMOVE STARTER COVER

a.
A215551

Remove the 3 bolts and starter cover.


Hide 28100 5.REMOVE STARTER ASSEMBLY

a.
A258285

Detach the 2 wire harness clamps.


b.

Disconnect the starter connector.


c.

Remove the nut and disconnect the starter wire.


d.
A258286

Remove the 2 bolts and starter.


e.
A215546

Remove the flywheel housing side cover.