Home › Drivetrain › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM27M0U _52 Drivetrain _049149 PROPELLER SHAFT _0234384 FRONT PROPELLER SHAFT ASSEMBLY A

PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  REASSEMBLY  


PROCEDURE

Hide 37401D 1.INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

C134387

a.

Apply MP grease to a new spider and bearings.

NOTICE:

Be careful not to apply too much grease.



b.

Fit the spider to the yoke.


c.
C159977E01
1.407,0.904 1.525,1.065 0.118,0.162 10 A 1.666,0.913 1.795,1.071 0.130,0.158 10 B

Measure dimension A between the snap ring grooves.


d.

Insert the spider bearing into the spider journal portion, and then measure dimension B of the universal joint.

NOTICE:

When measuring dimension B, fix the spider and needle roller bearings in a vise and hold them firmly together.



e.
G038874

Select snap rings to make dimensions A and B the same.

Snap ring type:
Color Thickness
Green 1.403 mm (0.0552 in.)
Black 1.486 mm (0.0585 in.)
Copper 1.512 mm (0.0595 in.)
White 1.556 mm (0.0613 in.)
Yellow 1.607 mm (0.0633 in.)
Blue 1.657 mm (0.0652 in.)


NOTICE:
·

Use new snap rings.

·

If possible, use snap rings of the same thickness for both edges.




f.
C353253E01
1.094,0.958 1.094,0.333 1.094,0.333 0.906,0.333 false 0.615,0.25 0.948,0.427 0.333,0.177 10 false SST

Insert the spider into the flange yoke, and then using SST, press in the spider bearing into the snap ring groove.

SST
09332-25010  

HINT:

Press in the spider bearing on the opposite side in the same way.


NOTICE:

When pressing in the spider bearing, be careful not to damage its lip.



g.
G038875

Using needle-nose pliers, install new snap rings into the grooves of the yoke.


Hide 37140 2.INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

Hide 37140 3.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

HINT:

When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration.


C158565E02
0.798,1.47 0.910,1.634 0.112,0.165 10 1 0.846,0.934 0.846,1.444 false 4.844,1.477 4.949,1.620 0.105,0.143 10 2 4.88,0.918 4.88,1.466 false 5.655,0.81 5.766,0.975 0.112,0.165 10 1 5.671,0.401 5.776,0.543 0.105,0.143 10 2

Text in Illustration
V100135

Rear Side - -