Home › Drivetrain › AXLE › STEERING KNUCKLE
RM27M0U _52 Drivetrain _049151 AXLE _0234391 STEERING KNUCKLE A

AXLE  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 43502C 1.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Remove the front axle hub (see page Drivetrain>AXLE>FRONT AXLE HUB>REMOVAL).


Hide 89543 2.DISCONNECT FRONT SPEED SENSOR LH

a.
C159315

Remove the clip and bolt.


b.

Disconnect the speed sensor from the steering knuckle.


Hide 45047 3.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Remove the cotter pin and nut.


b.
C179622E02
0.688,2.406 1.104,2.406 false 1.104,2.406 1.823,1.708 true 0.406,2.333 0.792,2.583 0.385,0.25 10 false SST

Using SST, disconnect the tie rod end LH from the steering knuckle.

SST
09610-20012  

NOTICE:
·

Do not damage the front disc brake dust cover.

·

Do not damage the ball joint dust cover.

·

Do not damage the steering knuckle.




Hide 48626 4.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

Hide 43212 5.REMOVE STEERING KNUCKLE LH

a.

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and the nut.


c.
C155977E02
2.469,1.385 2.135,1.385 true 2.385,1.313 2.698,1.51 0.313,0.198 10 true SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  


d.

Remove the steering knuckle.


Hide 43442B 6.REMOVE KNUCKLE GREASE RETAINER CAP LH (for 2WD)

a.
C159448

Using a screwdriver and hammer, tap out the retainer cap.


Hide 43212L 7.REMOVE STEERING KNUCKLE OIL SEAL LH (for 4WD)

a.
C159449

Using a screwdriver and hammer, tap out the oil seal.