Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234401 VEHICLE STABILITY CONTROL SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  TERMINALS OF ECU  


SKID CONTROL ECU


U152472E02
0.156,0 2.688,0.448 2.531,0.448 10 false Component without harness connected: (Skid Control ECU) 1.229,0.938 1.521,1.104 0.292,0.167 10 false A17

Terminal No. (Symbols) Terminal Description
A17-16 (GND1) Skid control ECU ground
A17-15 (STPO) Stop light control relay (BRK NO. 1) signal input
A17-14 (PKB2) Parking brake switch signal input
A17-13 (CANL) Vehicle CAN communication line
A17-12 (CANH) Vehicle CAN communication line
A17-11 (EXI2) A.D.D. detection switch signal input (4WD)
A17-10 (D/G) Diagnosis tester communication line
A17-9 No pin
A17-8 (IG1) IG1 power supply
A17-7 (TS) Sensor check input
A17-6 (STP2) Stop light switch signal input
A17-5 No pin
A17-4 (CSW) VSC OFF switch signal input
A17-3 (SP1) Vehicle speed pulse signal output
A17-2 No pin
A17-1 (+BM) Motor relay power supply
A17-31 (BST) Brake booster solenoid ground
A17-30 (PIM) Pedal stroke sensor (Delta S sensor) input line
A17-29 (GYAW) Yaw rate sensor ground
A17-28 No pin
A17-27 (E3) Pedal stroke sensor (Delta S sensor) ground
A17-26 (VCP) Pedal stroke sensor (Delta S sensor) power source
A17-25 No pin
A17-24 (PSNO) Brake booster micro switch (Normal Open) signal input
A17-23 (PSNC) Brake booster micro switch (Normal Close) signal input
A17-22 (VYS) Yaw rate sensor power source
A17-21 (STS) Brake booster micro switch power source
A17-20 No pin
A17-19 (SS2) Yaw rate sensor signal line
A17-18 (SS1) Yaw rate sensor signal line
A17-17 (BSTP) Brake booster solenoid power source
A17-47 No pin
A17-46 (FL-) Front wheel LH speed signal line
A17-45 (FL+) Front wheel LH speed signal line
A17-44 (BSW) Stop light control relay (BRK NO. 2) drive input
A17-43 (RR+) Rear wheel RH speed signal line
A17-42 (RR-) Rear wheel RH speed signal line
A17-41 No pin
A17-40 No pin
A17-39 No pin
A17-38 (STP) Stop light switch signal input
A17-37 (RL-) Rear wheel LH speed signal line
A17-36 (RL+) Rear wheel LH speed signal line
A17-35 No pin
A17-34 (FR+) Front wheel RH speed signal line
A17-33 (FR-) Front wheel RH speed signal line
A17-32 (+BS) Solenoid relay power supply


CHECK SKID CONTROL ECU


U152473E02
0.229,0.01 2.76,0.458 2.531,0.448 10 false Front view of wire harness connector: (Skid Control ECU) 1.292,0.938 1.583,1.104 0.292,0.167 10 false A17

a.

Disconnect the A17 ECU connector.


b.

Measure the voltage or resistance according to the value(s) in the table below.

HINT:

Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.


Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition
A17-16 (GND1) - Body ground W-B - Body ground Skid control ECU ground Always Below 1 Ω
A17-15 (STPO) - Body ground BR - Body ground Stop light control relay (BRK NO. 1) signal input Ignition switch ON 11 to 14 V
A17-14 (PKB2) - Body ground LG - Body ground Parking brake switch signal input Parking brake switch ON Below 1 Ω
A17-11 (EXI2) - Body ground GR - Body ground A.D.D. detection switch signal input (4WD) A.D.D. detection switch ON Below 1 Ω
A17-10 (D/G) - J17-7 (SIL) R - BR Diagnosis tester communication line Always Below 1 Ω
A17-8 (IG1) - Body ground V - Body ground IG1 power supply Ignition switch ON 11 to 14 V
A17-7 (TS) - J17-12 (TS) W - G Sensor check input Always Below 1 Ω
A17-6 (STP2) - Body ground GR - Body ground Stop light switch signal input Brake pedal depressed 8 to 14 V
Brake pedal released Below 1.5 V
A17-4 (CSW) - Body ground P - Body ground VSC OFF switch signal input VSC OFF switch ON Below 1 Ω
A17-3 (SP1) - Body ground G - Body ground Vehicle speed pulse signal output Always 11 to 14 V
A17-1 (+BM) - Body ground L - Body ground Motor relay power supply Always 11 to 14 V
A17-31 (BST) - A17-17 (BSTP) B - V Brake booster solenoid ground Always 1 to 2 Ω
A17-30 (PIM) - A17-27 (E3) R - BE Pedal stroke sensor (Delta S sensor) input line Always 4 to 8 kΩ
for 4WD:

A17-29 (GYAW) - P16-5 (GYAW)


P - G Yaw rate sensor ground Always Below 1 Ω
for 2WD:

A17-29 (GYAW) - P15-5 (GYAW)


A17-27 (E3) - Body ground BE - Body ground Pedal stroke sensor (Delta S sensor) ground Always 10 kΩ or higher
A17-26 (VCP) - A17-27 (E3) G - BE Pedal stroke sensor (Delta S sensor) power source Always 150 to 200 Ω
A17-23 (PSNC) - A17-21 (STS) L - SB Brake booster micro switch (Normal Close) signal input Always Below 1 Ω
A17-24 (PSNO) - A17-21 (STS) LG - SB Brake booster micro switch (Normal Open) signal input Brake pedal depressed Below 1 Ω
for 4WD:

A17-22 (VYS) - P16-3 (VYS)


R - R Yaw rate sensor power source Always Below 1 Ω
for 2WD:

A17-22 (VYS) - P15-3 (VYS)


A17-21 (STS) - A17-23 (PSNC) SB - L Brake booster micro switch power source Always Below 1 Ω
for 4WD:

A17-19 (SS2) - P16-1 (YAW2)


W - W Yaw rate sensor signal line Always Below 1 Ω
for 2WD:

A17-19 (SS2) - P15-1 (YAW2)


for 4WD:

A17-18 (SS1) - P16-2 (YAW1)


B - B Yaw rate sensor signal line Always Below 1 Ω
for 2WD:

A17-18 (SS1) - P15-2 (YAW1)


A17-17 (BSTP) - A17-31 (BST) V - B Brake booster solenoid power source Always 1 to 2 Ω
A17-46 (FL-) - b2-1 LG - B Front wheel LH speed signal line Always Below 1 Ω
A17-45 (FL+) - b2-2 V - W Front wheel LH speed signal line Always Below 1 Ω
A17-44 (BSW) - Body ground L - Body ground Stop light control relay (BRK NO. 2) drive input Ignition switch ON 11 to 14 V
A17-43 (RR+) - b3-2 B - W Rear wheel RH speed signal line Always Below 1 Ω
A17-42 (RR-) - b3-1 W - B Rear wheel RH speed signal line Always Below 1 Ω
A17-38 (STP) - Body ground B - Body ground Stop light switch signal input Brake pedal depressed 8 to 14 V
Brake pedal released Below 1.5 V
A17-37 (RL-) - b4-1 P - B Rear wheel LH speed signal line Always Below 1 Ω
A17-36 (RL+) - b4-2 L - W Rear wheel LH speed signal line Always Below 1 Ω
A17-34 (FR+) - b1-2 BE - W Front wheel RH speed signal line Always Below 1 Ω
A17-33 (FR-) - b1-1 G - B Front wheel RH speed signal line Always Below 1 Ω
A17-32 (+BS) - Body ground R - Body ground Solenoid relay power supply Always 11 to 14 V