BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
VEHICLE STABILITY CONTROL SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- CALIBRATION
- TEST MODE PROCEDURE
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- C1300/62 Malfunction in skid control ECU
- C1310/11 Open or short in active brake booster solenoid circuit.
- C1311/12, C1380/64
- C1336/39 When the vehicle is driven without completion of zero point calibration.
- C1340/47 When the terminal IG1 voltage is between 10 and 14 V, there is an open in the A.D.D. detection switch circuit...
- C1281/81, C1360/61
- C1370/73 Information relating to engine, transmission, drivetrain or destination stored in ECM does not match...
- C1439/66, C1445/66
- U0073/94, U0100/65, U0114/27, U0123/62, U0124/69, U0126/63
- C1290/66 Steering angle sensor zero point deviates from zero point stored in skid control ECU by 20 degrees or more.
- C1267/28 When one of following conditions is met: 1. Micro switch signal PSNC and PSNO logic malfunction. 2. When...
- C0273/13, C1251/51
- C1249/49 When one of following conditions is met: 1. When voltage of STP2 pin is detected to be outside range of 1.4...
- C1247/47 When either condition below is met: 1. When the output becomes 4.7 V or more or 0.2 V or less per 100 msec....
- C1241/41 When any of following conditions detected: 1. +BS terminal voltage 18 V or more (momentary occurrence...
- C1232/32, C1234/34, C1244/44, C1279/79
- C1231/31 When any of following conditions detected: 1. The ECU-B1 fuse blows or the ignition switch is turned to ON...
- C1207/37 When all conditions below are met: · Yaw rate sensor is normal. · G sensor lateral operation is normal. ·...
- C1203/53 When all of following conditions detected: 1. Engine variation data from ECM does not match one in skid...
- C1201/51 Engine control system malfunction signal continues for 1.2 seconds.
- C0278/11 When either of following conditions detected: 1. Malfunction in skid control ECU continues for 0.056 seconds...
- C0226/21, C0236/22, C0246/23, C0256/24, C1225/25, C1226/26, C1227/27, C1228/28
- C0210/33, C0215/34, C1273/73, C1274/74, C1277/77, C1278/78, C1332/37, C1333/38
- 43
- C0200/31, C0205/32, C1271/71, C1272/72, C1275/75, C1276/76, C1330/35, C1331/36
- ABS Warning Light Remains ON
- ABS Warning Light does not Come ON
- Brake Warning Light Remains ON
- Brake Warning Light does not Come ON
- TRAC OFF Indicator Light Remains ON
- TRAC OFF Indicator Light does not Come ON
- VSC OFF Indicator Light Remains ON
- VSC OFF Indicator Light does not Come ON
- Slip Indicator Light Remains ON
- Slip Indicator Light does not Come ON
- AUTO LSD Indicator Light Remains ON
- AUTO LSD Indicator Light does not Come ON
- TC and CG Terminal Circuit
- TS and CG Terminal Circuit
- Preparation
TRAILER BRAKE CONTROL SYSTEM
BRAKE ACTUATOR
FRONT SPEED SENSOR
REAR SPEED SENSOR
YAW RATE AND DECELERATION SENSOR
STEERING ANGLE SENSOR
VSC OFF SWITCH
STOP LIGHT CONTROL RELAY
TRAILER BRAKE CONTROL ECU