Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234402 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.DISCONNECT VSC ACTUATOR CONNECTOR

a.
C154434

Pull the release bar and disconnect the VSC actuator connector.


Hide 47311 4.REMOVE BRAKE TUBE

a.
U152153E01
0.347,1.407 0.528,1.553 0.181,0.147 10 *2 0.383,2.224 0.544,2.371 0.161,0.147 10 *4 2.573,1.353 2.755,1.518 0.181,0.165 10 *3 1.009,0.437 1.186,0.616 0.177,0.179 10 *5 0.348,0.07 0.533,0.249 0.185,0.179 10 *6 1.485,0.757 1.666,0.923 0.181,0.165 10 *1 1.544,2.203 0.644,1.487 0.644,1.487 0.547,1.487 false 1.714,2.476 0.574,2.316 false 2.052,1.577 2.172,1.434 2.172,1.434 2.556,1.434 false

Use tags or make a note to identify the reconnection locations.

HINT:
·

*1: FR RH

·

*2: FR LH

·

*3: RR RH

·

*4: RR LH

·

*5: FR Master Cylinder

·

*6: RR Master Cylinder




b.
C208906

Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.


c.
C208907

Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.


Hide 47312 5.DISCONNECT BRAKE TUBE

a.
C208908

Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.


b.

Remove the clamp from the VSC actuator bracket.


Hide 44540 6.REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY

a.
C155484

Remove the 3 nuts and VSC actuator with actuator bracket.