1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
42603
3.REMOVE REAR WHEEL
89546
4.REMOVE REAR SPEED SENSOR LH
Disconnect the speed sensor connector (labeled A).
Remove the nut (labeled B) and speed sensor (labeled C).
89545
5.REMOVE REAR SPEED SENSOR RH
Disconnect the speed sensor connector (labeled A).
Remove the nut (labeled B) and speed sensor (labeled C).
89516B
6.REMOVE SKID CONTROL SENSOR WIRE
Disconnect the sensor connector (labeled A).
Detach the 7 clips (labeled B).
Remove the bolt (labeled C).
Remove the nut (labeled D) and skid control sensor wire.