Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TRAILER BRAKE CONTROL SYSTEM
RM27M0U _54 Brake _049153 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0234409 TRAILER BRAKE CONTROL SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  TRAILER BRAKE CONTROL SYSTEM  TERMINALS OF ECU  


TERMINALS OF ECU


C309664E01
1.723,0.24 1.957,0.404 0.233,0.164 10 *a

Text in Illustration
*a Component without harness connected
(Trailer Brake Control ECU [Brake Control with Bracket Relay])
- -

Terminal No. (Symbol) Terminal Description
1 - (Not used)
2 (IG) IG power source
3 (TAIL) TAIL signal
4 (CANH) CAN communication line H
5 (GND) Trailer brake control ECU (Brake control with bracket relay) ground
6 (ILL-) Illumination signal
7 (BRK) Trailer brake output
8 (+B) Power supply (from battery)
9 (STOP) Stop light switch signal input
10 (CANL) CAN communication line L


TERMINAL INSPECTION


a.

Disconnect the J156 trailer brake control ECU (brake control with bracket relay) connector and measure the voltage or resistance on the wire harness side.

U152664E02
2.094,1.333 2.417,1.479 0.323,0.146 10 false J156 0.188,0.042 0.354,0.219 0.167,0.177 10 false *a

Text in Illustration
*a Front view of wire harness connector
(to Trailer Brake Control ECU [Brake Control with Bracket Relay])
- -

HINT:

Voltage cannot be measured with the connector connected to the trailer brake control ECU (brake control with bracket relay) as the connector is watertight.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
J156-2 (IG)- Body ground Y - Body ground IG power source Ignition switch ON 11 to 14 V
J156-5 (GND)- Body ground W-B - Body ground Trailer brake control ECU (Brake control with bracket relay) ground Always Below 1 Ω
J156-8 (+B)- Body ground B - Body ground Power supply (from battery) Always 11 to 14 V
J156-9 (STOP)- Body ground BR - Body ground Stop light switch signal input Brake pedal depressed 8 to 14 V
Brake pedal released Below 1.5 V