FUNCTION DESCRIPTION
| *1 | Trailer Brake Control ECU (Brake Control with Bracket Relay) | *2 | Trailer Brake TYPE Selection Button |
| *3 | GAIN (+/-) Selection Button | *4 | Manual Trailer Brake Output Slider |
Trailer Brake TYPE Selection Button:
The trailer brake type can be set by operating the trailer brake TYPE selection button.
GAIN (+/-) Selection Button:
The amount of brake force output to the trailer brake (gain value) can be set by operating the GAIN (+/-) selection button.
The gain value can be adjusted from 0 (no trailer brake) to 10 (maximum output) in 0.5 increments.
The gain value can be continuously increased/decreased by pressing and holding the button.
The gain value is displayed on the combination meter (multi-information display).
Manual Trailer Brake Output Slider:
The trailer brake can be operated by changing the position of the manual trailer brake output slider. When the manual trailer brake output slider is operated while the vehicle is braking, the larger of the 2 outputs is output to the trailer brake.
SETTING THE GAIN
It is necessary to set the gain value according to the specific towing condition.
Adjust the gain setting every time the vehicle load, trailer load, road condition or weather changes.
When the gain value is set to 0 (no trailer brake), there is no output from the trailer brake control ECU (brake control with bracket relay).
TRAILER BRAKE TYPE SETTING
The trailer brake type can be set by operating the trailer brake TYPE selection button.
Trailer brake type
Cycles between "Electric" and "Electric + Hydraulic".
"Electric" is set when an electric type trailer brake is connected.
"Electric + Hydraulic" is set when an electric + hydraulic type trailer brake is connected.
When the trailer brake TYPE selection button is pressed, the trailer brake type is shown on the combination meter (multi-information display).
FUNCTION OF COMPONENTS
| Components | Functions | |
|---|---|---|
| Trailer brake control ECU (Brake control with bracket relay) | ·
Receives the brake pedal operation signal from the skid control ECU and outputs a signal to the trailer brake. ·
When the manual trailer brake output slider is operated, outputs a signal to the trailer brake. ·
When the GAIN (+/-) selection button is operated, sets the amount of brake force output to the trailer brake (gain value). ·
When the trailer brake TYPE selection button is operated, sets the trailer brake type. |
|
| Skid control ECU | Outputs the vehicle speed signal and master cylinder pressure signal to the trailer brake control ECU (brake control with bracket relay). | |
| ECM | Outputs the shift position signal to the trailer brake control ECU (brake control with bracket relay). | |
| Combination meter | Multi-information display | ·
Displays the trailer link state. ·
Displays the gain value. ·
Displays output according to the manual trailer brake output slider operation. ·
Displays the trailer brake type. ·
Displays error notifications. |