The No. 1 damper servo sub-assembly (air mix servo motor) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the No. 1 damper servo sub-assembly (air mix servo motor) to any position. As a result the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the driver side is controlled.
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1441/41 | Air mix damper position sensor value does not change even if air conditioning amplifier operates No. 1 damper servo sub-assembly (air mix servo motor) | ·
No. 1 damper servo sub-assembly (air mix servo motor) ·
Air conditioning harness ·
Air conditioning amplifier |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse (D) | No. 1 damper servo sub-assembly (air mix servo motor) target pulse /
Min.: 0, Max.: 255 |
MAX. COLD: 5 (pulse)
MAX. HOT: 104 (pulse) |
- |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (Checking from the DTC) | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
A
B
C
Temporarily replace the No. 1 damper servo sub-assembly (air mix servo motor) with a new one (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.
NEXT
Check for DTC (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Replace the air conditioning harness.
NEXT
Check for DTC again (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
DTC is not output.
OK
NG