Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM27M0U _58 Vehicle Interior _049154 AIR CONDITIONING _0234411 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) C

AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  B1442/42  Air Inlet Damper Control Servo Motor Circuit  


DESCRIPTION

The air inlet damper servo motor sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (FRESH, FRESH / RECIRCULATION and RECIRCULATION).

HINT:

Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code DTC Detection Condition Trouble Area
B1442/42 Air inlet damper position sensor value does not change even if air conditioning amplifier operated air inlet damper servo motor
·

Air inlet servo motor

·

Air conditioning harness

·

Air conditioning amplifier



WIRING DIAGRAM

E147168E02
5.253,1.012 5.777,1.162 0.523,0.150 10 B BUS 5.253,1.648 5.691,1.798 0.438,0.150 10 BUS 5.253,2.283 5.792,2.425 0.539,0.142 10 BUS G 5.008,0.927 5.185,1.072 0.177,0.146 10 4 5.008,1.546 5.185,1.692 0.177,0.146 10 3 5.008,2.166 5.185,2.312 0.177,0.146 10 2 0.802,2.967 2.709,3.147 1.908,0.180 10 Air Inlet Servo Motor 3.131,3.015 4.747,3.172 1.616,0.158 10 Air Conditioning Harness 5.177,3.004 6.805,3.147 1.629,0.142 10 z1 5.177,3.155 6.805,3.298 1.629,0.143 10 Air Conditioning Amplifier

PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR INLET DAMPER TARGET PULSE)
a.

Use the Data List to check if the air inlet servo motor is functioning properly.

Air Conditioner
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
Air Inlet Damper Targ Pulse Air inlet damper target pulse /
Min.: 0, Max.: 255
REC: 7
FRS: 28
-

OK:

The display is as specified in the normal condition.


Result
Result Proceed to
OK (Checking from the DTC) A
OK (Checking from the PROBLEM SYMPTOMS TABLE) B
NG C



A

2.REPLACE AIR INLET SERVO MOTOR

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

2.REPLACE AIR INLET SERVO MOTOR
a.

Temporarily replace the air inlet servo motor with a new one (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.




NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

OK

END (AIR INLET SERVO MOTOR IS DEFECTIVE)

NG

4.REPLACE AIR CONDITIONING HARNESS
4.REPLACE AIR CONDITIONING HARNESS
a.

Replace the air conditioning harness.



NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC

OK

END (AIR CONDITIONING HARNESS IS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER