The blower motor is operated by signals from the air conditioning amplifier. Blower motor speed signals are transmitted by changes in the duty ratio.
Duty Ratio:
The duty ratio is the ratio of the blower motor OFF time (B) to the total of the blower motor ON and OFF time (A + B).
The blower motor controller controls the blower motor speed.
Select the Active Test, using the Techstream to generate a control command, and then check that the blower motor operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Blower Motor | Blower motor | Min.: 0, Max.: 31 | - |
| Result | Proceed to |
|---|---|
| NG (blower motor does not operate) | A |
| NG (blower motor operates but does not change speed) | B |
| OK | C |
A
B
C
Remove the HTR H-fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| HTR H-fuse | Always | Below 1 Ω |
OK
NG
Disconnect the J32 blower motor connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J32-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J32-3 (+B) - Body ground | Always | 11 to 14 V |
OK
NG
Disconnect the J19 air conditioning amplifier connector.
Disconnect the J32 blower motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J19-23 (BLW) - J32-2 (S1) | Always | Below 1 Ω |
| J19-23 (BLW) or J32-2 (S1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the J19 air conditioning amplifier connector.
Reconnect the J32 blower motor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J19-23 (BLW) - Body ground | Ignition switch ON | 4.5 to 5.5 V |
OK
NG
Remove the air conditioning amplifier with its connectors still connected (see page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL).
Turn the ignition switch ON.
Turn the blower switch LO.
Using an oscilloscope, check the waveform.
| Tester Connection | Tool Setting | Switch Condition | Specified Condition |
|---|---|---|---|
| J19-23 (BLW) - J19-14 (GND) | 1 V/DIV., 500 μsec./DIV. | Ignition switch ON
Blower switch LO |
Pulse generation |
Waveform varies with the blower level.
OK
NG