88515
1.INSTALL COOLER EXPANSION VALVE
Sufficiently apply compressor oil to 4 new O-rings and the fitting surface of the hose joint.
ND-OIL 8 or equivalent
Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.
Install the 2 O-rings to the tube and accessory.
Install the cooler expansion valve and tube and accessory to the No. 1 cooler evaporator sub-assembly.
Using a 4 mm hexagon wrench, install the 2 bolts.
88625Q
2.INSTALL NO. 1 COOLER THERMISTOR
88501
3.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Install the No. 1 cooler evaporator sub-assembly to the blower case (front side).
Install the blower case (back side).
Install the 6 screws and attach the 3 claws.
Install the No. 2 cooling unit packing and No. 1 cooling unit packing as shown in the illustration.
87107A
4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
Install the heater radiator unit sub-assembly.
Attach the 3 claws to install the heater clamp.
Install the plate with the 3 screws.
87106B
5.INSTALL COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Install the cooling unit damper servo sub-assembly with the 3 screws as shown in the illustration.
Connect the connector.
87106G
6.INSTALL BLOWER DAMPER SERVO SUB-ASSEMBLY
Install the blower damper servo sub-assembly with the 3 screws.
Connect the connector.
7.INSTALL BLOWER UPPER CASE SUB-ASSEMBLY
Attach the 2 claws to install the blower upper case sub-assembly.
Install the 3 screws.
87106L
8.INSTALL DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Install the damper servo sub-assembly with the 3 screws.
Connect the connector.
87106D
9.INSTALL NO. 1 DAMPER SERVO SUB-ASSEMBLY
Set the No. 1 damper servo sub-assembly so that the cutout part engages with the tooth of the gear, and attach the claw to install the No. 1 damper servo sub-assembly.
| *A | Air Conditioning Unit Side | *B | Damper Servo Side |
| *1 | Cutout | *2 | Tooth |
|
Rotate lever in direction of arrow until it stops | - | - |
Install the 4 screws and connect the 2 connectors.
10.INSTALL AIR DUCT
Install the air duct with the 2 screws.
87103B
11.INSTALL BLOWER WITH FAN MOTOR SUB-ASSEMBLY
Install the blower with fan motor sub-assembly with the 3 screws.
88650E
12.INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
87201F
13.INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY
Install the No. 3 air duct sub-assembly with the screw.
87139C
14.INSTALL CLEAN AIR FILTER
Install the clean air filter as shown in the illustration.
88899M
15.INSTALL AIR FILTER COVER PLATE
Attach the 2 claws to install the air filter cover plate.
87201
16.INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY
Attach the 4 claws to install the No. 1 air duct sub-assembly.
55990B
17.INSTALL LOWER DEFROSTER NOZZLE ASSEMBLY
Attach the 4 claws to install the lower defroster nozzle assembly.