B2793 is output when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if the key code registration cannot be performed normally and this DTC is detected.
B2794 is output when a key with an incomplete key code is inserted into the ignition key cylinder.
B2795 is output when a key with a key code that has not been registered in the ECU is inserted into the ignition key cylinder.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2793 | Transponder chip malfunction | Key |
| B2794 | Key with incomplete key code is inserted | |
| B2795 | Key with unregistered key code is inserted |
Clear the DTCs (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Reregister the key code with the transponder key ECU (see page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>REGISTRATION).
Check that the engine starts with the key.
Engine starts.
OK
NG