ENGINE IMMOBILISER
ENGINE IMMOBILISER SYSTEM
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- REGISTRATION
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B279A When communication line (EFIO-IMI) between ECM and transponder key ECU is stuck on HI output for 6 seconds or...
- B2797 Keys are positioned too close to each other, or noise occurred in communication line
- B2799 One of following conditions is met: · Error in communication between ECM and transponder key ECU · Error in...
- B279C ECM for vehicle without engine immobiliser system is installed on vehicle with engine immobiliser system
- B2796, B2798
- B2780 Unlock warning switch ON is not detected when the ignition switch is ON.
- B2784 Antenna coil is open/shorted
- B2793, B2794, B2795
- Security Indicator Light Circuit
- ECU Power Source Circuit
- Diagnosis Circuit
- Preparation