In this circuit, the combination meter receives the engine coolant temperature signals from the ECM using the CAN communication lines. The combination meter displays an engine coolant temperature that is calculated based on the data received from the ECM.
Check if a CAN communication system DTC is output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
B
Check if a SFI system DTC is output.
for 1UR-FE (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR)
for 3UR-FE (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR)
for 3UR-FBE (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR)
| Result | Proceed to |
|---|---|
| SFI system DTC is not output | A |
| SFI system DTC (for 1UR-FE) is output | B |
| SFI system DTC (for 3UR-FE) is output | C |
| SFI system DTC (for 3UR-FBE) is output | D |
A
B
C
D