1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)
Disable the Autoaway/Return function by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).
Record the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.
Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.
Turn the ignition switch off.
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55061
4.REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
55318C
5.REMOVE INSTRUMENT SIDE PANEL LH
55479B
6.REMOVE LOWER CENTER INSTRUMENT COVER (for Column Shift Type)
67914
7.REMOVE FRONT DOOR SCUFF PLATE LH
for Double Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL)
for CrewMax:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>REMOVAL)
for Regular Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL)
62112
8.REMOVE COWL SIDE TRIM BOARD LH
55046A
9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
55474C
10.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
45287
11.REMOVE LOWER STEERING COLUMN COVER (for Column Shift Type)
45286B
12.REMOVE UPPER STEERING COLUMN COVER (for Column Shift Type)
55447C
13.REMOVE NO. 2 SWITCH HOLE BASE
55471A
14.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
for Column Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL)
for Floor Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>REMOVAL)
55410C
15.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
for Column Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL)
for Floor Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>REMOVAL)
83100
16.REMOVE COMBINATION METER ASSEMBLY
for Floor Shift Type:
Apply protective tape as shown in the illustration.
| *A | for Column Shift Type | *B | for Floor Shift Type |
| *1 | Protective Tape | - | - |
Remove the 4 screws.
Move the combination meter assembly as shown in the illustration and disconnect the connector and detach the wire harness clamp.
| *A | for Column Shift Type | *B | for Floor Shift Type |
Pass the combination meter assembly between the steering wheel assembly and instrument panel.