This DTC is stored when items controlled by the front power seat switch LH cannot be customized via the navigation system vehicle customization screen.
The front power seat switch LH controls the front power seat control system (w/ Memory) related items that are customizable via the navigation receiver assembly screen.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15F8 | Front power seat switch LH vehicle setting processing error. | ·
CAN communication system ·
Front power seat control system (w/ Memory) ·
Front power seat switch LH ·
Navigation receiver assembly |
Use the Techstream to check if the CAN communication system is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
CAN communication system DTCs are not output.
OK
NG
Check if the front power seat control system (w/ Memory) is malfunctioning (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>HOW TO PROCEED WITH TROUBLESHOOTING).
Customization may not be possible depending on the malfunction in the front power seat control system (w/ Memory).
No malfunctions are present in the front power seat control system (w/ Memory).
OK
NG
(See pageVehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>HOW TO PROCEED WITH TROUBLESHOOTING)
Display the "Vehicle Customization" screen.
Make a note of the customizable items for front power seat switch LH related system.
These items shown as customizable via the navigation receiver assembly vehicle customization screen can also be changed using the Techstream. In a following step, the Techstream will be used.
Check the customize parameters list for the front power seat control system (w/ Memory) related items that can be customized via the navigation receiver assembly screen (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)>CUSTOMIZE PARAMETERS).
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the navigation receiver assembly screen.
The items available for customization via the navigation receiver assembly screen can be customized successfully using the manual procedure.
| Result | Proceed to |
|---|---|
| OK (for Column Shift Type) | A |
| OK (for Floor Shift Type) | B |
| NG | C |
A
B
C