Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049158 NAVIGATION / MULTI INFO DISPLAY _0234440 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1532  LVDS Signal Malfunction (from Extension Module)  B156C  Extension Module Disconnected  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
B1532 When either condition below is met:
·

Video signal (digital) is lost.

·

The stereo component tuner assembly is not connected while the ignition switch is ON or ACC.

·

Communication between the navigation receiver assembly and the stereo component tuner assembly is not possible when the engine is started.


·

No. 1 navigation wire

·

Stereo component tuner assembly

·

Navigation receiver assembly

·

Harness or connector


B156C

WIRING DIAGRAM

E282848E01
0.667,0.438 1.094,0.604 0.427,0.167 10 false US4- 0.646,0.875 1.073,1.042 0.427,0.167 10 false US4+ 0.656,1.313 1.083,1.479 0.427,0.167 10 false UGD4 0.667,1.729 1.094,1.896 0.427,0.167 10 false USV4 0.656,2.198 1.083,2.365 0.427,0.167 10 false USG4 0.792,2.906 1.219,3.073 0.427,0.167 10 false +B 0.667,3.344 1.094,3.51 0.427,0.167 10 false ACC2 0.646,3.781 1.073,3.948 0.427,0.167 10 false GND2 0.667,4.323 1.094,4.49 0.427,0.167 10 false LV1 0.156,5.427 1.365,5.813 1.208,0.385 10 false Stereo Component Tuner Assembly 2.885,5.583 4.354,5.771 1.469,0.188 10 false No. 1 Navigation Wire 0.771,6.385 3.865,6.563 3.094,0.177 10 false : LVDS Communication Line 1.24,0.438 1.51,0.604 0.271,0.167 10 false K2 1.219,0.865 1.49,1.031 0.271,0.167 10 false K2 1.229,1.323 1.5,1.49 0.271,0.167 10 false K2 1.219,1.76 1.49,1.927 0.271,0.167 10 false K2 1.229,2.198 1.5,2.365 0.271,0.167 10 false K2 1.229,2.906 1.5,3.073 0.271,0.167 10 false L3 1.229,3.354 1.5,3.521 0.271,0.167 10 false L3 1.219,3.771 1.49,3.938 0.271,0.167 10 false L3 1.219,4.344 1.49,4.51 0.271,0.167 10 false K4 1.292,0.208 1.563,0.375 0.271,0.167 10 false 2 1.271,0.667 1.542,0.833 0.271,0.167 10 false 3 1.271,1.104 1.542,1.271 0.271,0.167 10 false 4 1.271,1.542 1.542,1.708 0.271,0.167 10 false 1 1.281,1.979 1.552,2.146 0.271,0.167 10 false 5 1.281,2.656 1.552,2.823 0.271,0.167 10 false 4 1.271,3.125 1.542,3.292 0.271,0.167 10 false 3 1.271,3.563 1.542,3.729 0.271,0.167 10 false 8 1.26,4.104 1.531,4.271 0.271,0.167 10 false 1 5.76,0.438 6.031,0.604 0.271,0.167 10 false K1 5.76,0.875 6.031,1.042 0.271,0.167 10 false K1 5.75,1.323 6.021,1.49 0.271,0.167 10 false K1 5.75,1.75 6.021,1.917 0.271,0.167 10 false K1 5.76,2.188 6.031,2.354 0.271,0.167 10 false K1 5.781,2.896 6.052,3.063 0.271,0.167 10 false L1 5.792,3.344 6.063,3.51 0.271,0.167 10 false L1 5.781,3.771 6.052,3.938 0.271,0.167 10 false L1 5.771,4.333 6.042,4.5 0.271,0.167 10 false K3 5.781,5.385 7.063,5.719 1.281,0.333 10 false Navigation Receiver Assembly 6.135,0.417 6.563,0.583 0.427,0.167 10 false US4- 6.156,0.885 6.583,1.052 0.427,0.167 10 false US4+ 6.104,1.323 6.531,1.49 0.427,0.167 10 false UGD4 6.115,1.74 6.542,1.906 0.427,0.167 10 false USV4 6.115,2.198 6.542,2.365 0.427,0.167 10 false USG4 6.115,2.896 6.625,3.073 0.51,0.177 10 false +B2 6.115,3.344 6.542,3.51 0.427,0.167 10 false ACC2 6.115,3.802 6.542,3.969 0.427,0.167 10 false GND2 6.146,4.333 6.573,4.5 0.427,0.167 10 false LV1 5.781,0.208 6.052,0.375 0.271,0.167 10 false 2 5.813,0.677 6.083,0.844 0.271,0.167 10 false 3 5.823,1.115 6.094,1.281 0.271,0.167 10 false 4 5.781,1.531 6.052,1.698 0.271,0.167 10 false 1 5.823,1.979 6.094,2.146 0.271,0.167 10 false 5 5.792,2.667 6.063,2.833 0.271,0.167 10 false 4 5.813,3.115 6.083,3.281 0.271,0.167 10 false 3 5.802,3.563 6.073,3.729 0.271,0.167 10 false 8 5.833,4.094 6.104,4.26 0.271,0.167 10 false 1 3.323,2.375 3.958,2.552 0.635,0.177 10 false Shielded

CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.


PROCEDURE

1.CHECK FOR DTC

OK

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
a.

Disconnect the K1 and L1 navigation receiver assembly connectors.


b.

Disconnect the K2 and L3 stereo component tuner assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K1-1 (USV4) - K2-1 (USV4) Always Below 1 Ω
K1-2 (US4-) - K2-2 (US4-) Always Below 1 Ω
K1-3 (US4+) - K2-3 (US4+) Always Below 1 Ω
K1-4 (UGD4) - K2-4 (UGD4) Always Below 1 Ω
K1-5 (USG4) - K2-5 (USG4) Always Below 1 Ω
L1-4 (+B2) - L3-4 (+B) Always Below 1 Ω
L1-3 (ACC2) - L3-3 (ACC2) Always Below 1 Ω
L1-8 (GND2) - L3-8 (GND2) Always Below 1 Ω
K1-1 (USV4) - Body ground Always 10 kΩ or higher
K1-2 (US4-) - Body ground Always 10 kΩ or higher
K1-3 (US4+) - Body ground Always 10 kΩ or higher
K1-4 (UGD4) - Body ground Always 10 kΩ or higher
K1-5 (USG4) - Body ground Always 10 kΩ or higher
L1-4 (+B2) - Body ground Always 10 kΩ or higher
L1-3 (ACC2) - Body ground Always 10 kΩ or higher
L1-8 (GND2) - Body ground Always 10 kΩ or higher




OK

3.CHECK NO. 1 NAVIGATION WIRE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK NO. 1 NAVIGATION WIRE

OK

END (NO. 1 NAVIGATION WIRE IS DEFECTIVE)

NG

4.CHECK STEREO COMPONENT TUNER ASSEMBLY
4.CHECK STEREO COMPONENT TUNER ASSEMBLY
a.

Replace the stereo component tuner assembly with a known good one.

for Column Shift Type: See page Audio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER(for Column Shift Type)>REMOVAL

for Floor Shift Type: See page Audio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER(for Floor Shift Type)>REMOVAL



c.

Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.


Result
Result Proceed to
OK A
NG (for Column Shift Type) B
NG (for Floor Shift Type) C



A

END (STEREO COMPONENT TUNER ASSEMBLY IS DEFECTIVE)

B

C