1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55479B
3.REMOVE CENTER LOWER INSTRUMENT COVER
55900
4.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
86140A
5.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
86842
6.REMOVE NO. 1 NAVIGATION WIRE
Disconnect each connector and remove the No. 1 navigation wire.
86211J
7.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 5 bolts and No. 1 radio receiver bracket.
86212C
8.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 5 bolts and No. 2 radio receiver bracket.
86180
9.REMOVE STEREO COMPONENT TUNER ASSEMBLY
Detach the 2 guides and remove the stereo component tuner assembly as shown in the illustration.