Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)
RM27M0U _58 Vehicle Interior _049161 WINDOW / GLASS _0234473 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  All Power Windows does not Operate with Door Key Cylinder  


DESCRIPTION

When the driver door key cylinder (key linked switch) is turned, the following occurs: 1) the door lock motor receives the signal; 2) the main body ECU (driver side junction block) sends the signal to the power window regulator motors; and 3) the power window motors are activated.

PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
a.

Check for LIN communication system DTCs related to the power window control system.

OK:

LIN communication system DTCs are not output.




OK

2.CHECK FOR DTC (B2312)

NG

2.CHECK FOR DTC (B2312)
a.

Check if DTC B2312 is output (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>DTC CHECK / CLEAR).

OK:

DTC B2312 is not output.




OK

3.READ VALUE USING TECHSTREAM (DOOR LOCK SWITCH)

NG

3.READ VALUE USING TECHSTREAM (DOOR LOCK SWITCH)
a.

Use the Data List to check if the door lock switch is functioning properly.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Door Key SW-Lock Door key linked lock switch signal / ON or OFF ON: Driver side door key cylinder is turned to lock position
OFF: Driver side door key cylinder is not turned
-
Door Key SW-Unlock Door key linked unlock switch signal / ON or OFF ON: Driver side door key cylinder is turned to unlock position
OFF: Driver side door key cylinder is not turned
-

OK:

On the Techstream screen, each item changes between ON and OFF according to above chart.




OK

4.CHECK POWER WINDOW MANUAL FUNCTION

NG

4.CHECK POWER WINDOW MANUAL FUNCTION
a.

Check that the manual UP/DOWN function using the master switch can operate the front door power window LH and RH (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>OPERATION CHECK).



OK

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)

NG

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE