The LIN communication of the components related to the mirror heater occurs between the air conditioning amplifier assembly and air conditioning control assembly.
When using the Techstream with the ignition switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
Disconnect the J127 air conditioning control assembly connector.
Disconnect the J19 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J19-37 (LIN1) - J127-7 (STX) | Always | Below 1 Ω |
| J19-37 (LIN1) or J127-7 (STX) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the J127 air conditioning control assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J127-5 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J127-4 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch OFF | Below 1 V |
OK
NG
Temporarily replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING PANEL>REMOVAL).
Check that the malfunction disappears.
Malfunction disappears.
OK
NG