Power Source / Network
MULTIPLEX COMMUNICATION
LIN COMMUNICATION SYSTEM
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B2325 The main body ECU (driver side junction block) detects a malfunction in the LIN communication bus between...
- B2322 No communication between the front power window regulator motor assembly RH and main body ECU (driver side...
- B2321 No communication between the front power window regulator motor assembly LH and main body ECU (driver side...
- B1273 No communication between sliding roof drive gear sub-assembly and main body ECU (driver side junction block)...
- B1206 No communication between the power window regulator master switch assembly and main body ECU (driver side...
- Integration Control and Panel Assembly Communication Error
CAN COMMUNICATION
CAN COMMUNICATION SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- FAIL-SAFE CHART
- DIAGNOSTIC TROUBLE CODE CHART
- U1115 There is no communication from the multiplex tilt and telescopic ECU.
- U1002 (CAN No. 2 BUS)
- U1002 Lost communication with gateway module
- U0233 There is no communication from the blind spot monitor sensor RH.
- U0199 There is no communication from the outer mirror control ECU assembly.
- U0208 There is no communication from the front power seat control ECU with switch LH.
- Skid Control ECU Communication Stop Mode
- Trailer Brake Controller Communication Stop Mode
- Air Conditioning Amplifier Communication Stop Mode
- Gateway ECU Communication Stop Mode
- Steering Angle Sensor Communication Stop Mode
- ECM Communication Stop Mode
- Main Body ECU Communication Stop Mode
- Combination Meter ECU Communication Stop Mode
- Center Airbag Sensor Communication Stop Mode
- 4WD Control ECU Communication Stop Mode
- Navigation ECU Communication Stop Mode
- Audio Receiver Assembly Communication Stop Mode
- Bus Buffer ECU Communication Stop Mode
- Open in CAN Main Wire
- Short in CAN Bus Lines
- Short to B+ in CAN Bus Line
- Short to GND in CAN Bus Line
- Open in One Side of CAN Branch Line