The ECM is connected to the CAN communication system.Therefore, before starting troubleshooting, make sure tocheck that there is no trouble in the CAN communicationsystem.
*: Use the Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the DTC Check / Clear.
Click hereDrivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Check Mode Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Road Test.
Click hereDrivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>ROAD TEST
| Result | Proceed to |
|---|---|
| Symptom does not occur | A |
| Symptom occurs | B |
A
B
Refer to the Electronic Circuit Inspection Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the DTC Check / Clear.
Click hereDrivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to the Park/Neutral Position Switch.
Refer to the Shift Lever Assembly.
for Column Shift Type, refer to the following procedures
for Floor Shift Type, refer to the following procedures
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Mechanical System Tests.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Hydraulic Test.
Click hereDrivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>HYDRAULIC TEST
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Manual Shifting Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT