Home › Drivetrain › K320 (MULTIDRIVE / CVT) › TRANSMISSION WIRE
RM3700E _52 Drivetrain _092906 K320 MULTIDRIVE / CVT _0438041 TRANSMISSION WIRE A

K320 MULTIDRIVE / CVT  TRANSMISSION WIRE  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C430092N02
1.906,3.833 2.49,3.833 false 2.083,1.104 2.667,1.104 false 2.552,3.708 2.833,4.063 0.281,0.354 18 false 1 1.885,0.979 2.167,1.333 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 TRANSMISSION VALVE BODY ASSEMBLY 35410J - - -
2 TRANSMISSION WIRE 82125M (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission wire removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air intake system parts Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 82125M 2.REMOVE TRANSMISSION WIRE

a.
C449858C01
0.427,0.365 0.708,0.719 0.281,0.354 18 false i 4.26,0.927 4.542,1.281 0.281,0.354 18 false ii 0.365,2.521 0.646,2.875 0.281,0.354 18 false iii
V113147

Release the lock lever - -


i.

Release the lock lever and disconnect the transmission wire connector.


ii.

Disconnect the transmission revolution sensor (NC1) connector.


iii.

Remove the bolt and transmission wire from the transaxle case sub-assembly.