| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | TRANSAXLE SIDE COVER SUB-ASSEMBLY | 35015Y | - | - | - |
| 2 | TRANSMISSION WIRE | 82125M | ( )
|
- | - |
| 3 | TRANSMISSION VALVE BODY ASSEMBLY | 35410J | ( )
|
- | - |
| *1 | TEMPERATURE SENSOR | *2 | TEMPERATURE SENSOR CLAMP |
| *3 | FRONT OIL PUMP COVER GASKET | *4 | TRANSAXLE CASE GASKET |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission valve body assembly removal/installation are shown below.
Shift shock may increase after replacing the transmission valve body assembly. In this case, shift shock will reduce as the vehicle is driven.
35015Y
1.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY
82125M
2.REMOVE TRANSMISSION WIRE
Disengage the clamp to disconnect the transmission wire from the solenoid lock plate.
Disconnect the 6 solenoid valve connectors.
Remove the bolt and temperature sensor clamp from the transmission valve body assembly.
Disconnect the temperature sensor from the transmission valve body assembly.
Remove the O-ring from the temperature sensor.
35410J
3.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Move the shift lever to D.
| *1 | Transaxle Case Gasket | *2 | Front Oil Pump Cover Gasket |
Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.
Make sure the manual valve does not fall out when removing the transmission valve body assembly, as the manual valve is not secured to the transmission valve body assembly.
Remove the front oil pump cover gasket from the transaxle case sub-assembly.
Remove the 3 transaxle case gaskets from the transaxle case sub-assembly.