| *1 | TEMPERATURE SENSOR | *2 | TEMPERATURE SENSOR CLAMP |
| *3 | FRONT OIL PUMP COVER GASKET | *4 | TRANSAXLE CASE GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
Toyota Genuine CVT Fluid FE |
| ● | Non-reusable part | - | - |
Shift shock may increase after replacing the transmission valve body assembly. In this case, shift shock will reduce as the vehicle is driven.
35410J
1.INSTALL TRANSMISSION VALVE BODY ASSEMBLY
|
|
| *1 | Manual Valve | *2 | Manual Valve Link Lever Sub-assembly |
| *3 | Transaxle Case Gasket | *4 | Front Oil Pump Cover Gasket |
Coat 3 new transaxle case gaskets with Toyota Genuine CVT fluid FE and install them to the transaxle case sub-assembly.
Coat a new front oil pump cover gasket with Toyota Genuine CVT fluid FE and install it to the transaxle case sub-assembly.
Align the slit portion of the manual valve and the manual valve link lever sub-assembly as shown in the illustration, and temporarily install the transmission valve body assembly to the transaxle case sub-assembly with the 2 bolts.
40 mm (1.57 in.)
Securely align the wire harness with the cutout of the transaxle case sub-assembly.
Temporarily install the 9 bolts.
| Bolt (A) | Bolt (B) |
|---|---|
| 40 mm (1.57 in.) | 55 mm (2.17 in.) |
82125M
2.INSTALL TRANSMISSION WIRE
Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the temperature sensor.
Connect the temperature sensor to the transmission valve body assembly.
To prevent it from being pinched between the transmission valve body assembly and the transaxle side cover sub-assembly, do not let the transmission wire ride up over the area shown in the illustration.
|
Do not let transmission wire protrude into this area. | - | - |
Temporarily install the temperature sensor clamp to the transmission valve body assembly with the bolt.
55 mm (2.17 in.)
Fully tighten the 12 bolts.
Connect the 6 solenoid valve connectors.
Engage the clamp to connect the transmission wire to the solenoid lock plate.
35015Y
3.INSTALL TRANSAXLE SIDE COVER SUB-ASSEMBLY
4.CHECK CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
If continuously variable transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.
Click hereDrivetrain>K320 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PRECAUTION