| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | TRANSAXLE SIDE COVER SUB-ASSEMBLY | 35015Y | ( )
|
- | - |
| *1 | REFILL PLUG | *2 | OVERFLOW PLUG |
| *3 | OVERFLOW (CVT) TUBE | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |
|
Toyota Genuine CVT Fluid FE |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | WIRE HARNESS CLAMP BRACKET | - | - | - | - |
| 3 | ENGINE WIRE | 82121 | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | AIR CLEANER CASE SUB-ASSEMBLY | 17701 | - | - | - |
| 5 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | 17801 | - | - | - |
| 6 | AIR CLEANER CAP WITH AIR CLEANER HOSE | 17705 | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
35015Y
1.INSTALL TRANSAXLE SIDE COVER SUB-ASSEMBLY
|
Area to be Cleaned | - | - |
Clean the transaxle side cover sub-assembly installation surface of the transaxle case sub-assembly.
Completely remove any oil or grease from the contact surfaces of the transaxle case sub-assembly.
Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the transaxle side cover sub-assembly.
Temporarily install a new transaxle side cover sub-assembly to the transaxle case sub-assembly with the 11 bolts.
Fully tighten the 11 bolts in the order shown in the illustration.
2.INSTALL WIRE HARNESS CLAMP BRACKET
82121
3.INSTALL ENGINE WIRE
17701
4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
5.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17705
6.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
7.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
8.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK
51442C
9.INSTALL ENGINE UNDER COVER LH
51410
10.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY