Home › Drivetrain › K320 (MULTIDRIVE / CVT) › REVOLUTION SENSOR (NSS SENSOR)
RM3700E _52 Drivetrain _092906 K320 MULTIDRIVE / CVT _0438047 REVOLUTION SENSOR(NSS SENSOR) A

K320 MULTIDRIVE / CVT  REVOLUTION SENSOR(NSS SENSOR)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C430090N02
5,3.167 5.333,3.167 false 4.75,3.146 4.833,3.646 4.833,3.646 5,3.646 false 5.802,3.885 5.969,3.385 5.969,3.385 6.135,3.385 false 5.385,3.063 5.667,3.417 0.281,0.354 18 false 2 5.052,3.583 5.667,3.781 0.615,0.198 10 false ● 6.167,3.26 6.448,3.615 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 TCM 89535B - - -
2 TRANSMISSION REVOLUTION SENSOR (NSS) 89413T - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor (NOUT) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Air intake system parts Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 89535B 1.REMOVE TCM

Hide 89413T 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NSS)

a.
C431084