|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
for Gasoline Model:
Compressor oil ND-OIL 8 or equivalent for HV Model: Compressor oil ND-OIL 11 or equivalent |
- | - |
88625
1.INSTALL NO. 1 COOLER THERMISTOR
| *a | Securing Part | *b | Sensor Part |
Install the No. 1 cooler thermistor as shown in the illustration.
| Part | Length |
|---|---|
| A | 45 to 55 mm (1.77 to 2.17 in.) |
| B | 61.1 mm (2.41 in.) |
Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).
After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.
Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
87107A
3.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
87124B
4.INSTALL HEATER CLAMP
88897K
6.INSTALL COOLER PIPE GROMMET
87130D
8.INSTALL BLOWER ASSEMBLY