Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › 2020.08–2021.07
RM3700E _57 Power Source / Network _093026 NETWORKING _0438527 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E448355N03
5.667,2.167 5.917,2.167 false 3.208,1.333 3.542,1.333 false 0.76,1.333 1.094,1.333 false 0.604,1.198 0.885,1.552 0.281,0.354 18 false 1 5.479,2.042 5.667,2.333 0.188,0.292 18 false 2 3.01,1.25 3.385,1.49 0.375,0.24 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 POWER DISTRIBUTION BOX ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU - - - -
2 NETWORK GATEWAY ECU 89111 (Click here) - -

*1 ECU INTEGRATION BOX LH - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the horn button assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Central gateway ECU (network gateway ECU) Update ECU security key - (Click here)

PROCEDURE

Hide 1.REMOVE POWER DISTRIBUTION BOX ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU

Hide 89111 2.REMOVE NETWORK GATEWAY ECU

Z101186

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the claws more than necessary.




a.
E448356N01
2.292,0.104 2.573,0.458 0.281,0.354 18 false i

i.

Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the network gateway ECU.