| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | ULTRASONIC SENSOR CUSHION SET | - | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
89341L
2.REMOVE FRONT CENTER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
89341K
3.REMOVE FRONT CORNER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
89347B
4.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER
|
|
|
Heated Area | - | - |
Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Front Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Front Corner Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front bumper assembly and front corner ultrasonic sensor retainer excessively.
Remove the front corner ultrasonic sensor retainer.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
5.REMOVE ULTRASONIC SENSOR CUSHION SET
|
|