| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT FENDER MOULDING SUB-ASSEMBLY LH | 75602A | - | - | - |
| 2 | FRONT FENDER MOULDING SUB-ASSEMBLY RH | 75601A | - | - | - |
| 3 | FRONT BUMPER ASSEMBLY | - | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
75602A
1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
75601A
2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
3.REMOVE FRONT BUMPER ASSEMBLY
|
Remove in this Direction | - | - |
Apply protective tape around the front bumper assembly.
Remove the 4 screws.
Disengage the claws as shown in the illustration.
| *a | Clip | *b | Bolt |
Pull back the side of the front bumper assembly to disconnect the 3 connectors.
Do not apply excessive force when pulling back the front bumper assembly.
Disconnect the 2 connectors.
Remove the 2 screws and 2 bolts.
Remove the front bumper assembly.