| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | STOP LIGHT SWITCH MOUNTING ADJUSTER | 84345 | - | - | - |
| 2 | STOP LIGHT SWITCH ASSEMBLY | 84340 | ( )
|
- | - |
| 3 | NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY | 55606 | - | - | - |
| ● | Non-reusable part | - | - |
84345
1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
84340
2.INSTALL STOP LIGHT SWITCH ASSEMBLY
| *1 | Stop light switch mounting adjuster | - | - |
| *a | Protrusion Amount Measurement Area | - | - |
|
Install in this Direction | - | - |
Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.
Do not depress the brake pedal.
Turn the stop light switch assembly clockwise by approximately one fourth of a rotation.
Check the protrusion amount of the shaft.
| Area | Measurement |
|---|---|
| a | 0.5 to 2.6 mm (0.0197 to 0.102 in.) |
Connect the connector.
Check that the stop light does not come on when the brake pedal is not depressed.
55606
3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY