| ● | Non-reusable part | ★ | Precoated part |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head removal/installation are shown below.
13741A
1.REMOVE VALVE SPRING RETAINER LOCK
Using SST, compress each compression spring and remove the 12 valve spring retainer locks.
2.REMOVE VALVE SPRING RETAINER
13711M
3.REMOVE INTAKE VALVE COMPRESSION SPRING
13715H
4.REMOVE EXHAUST VALVE COMPRESSION SPRING
Remove using the same procedure as for the intake valve compression spring.
13711
5.REMOVE INTAKE VALVE
13715
6.REMOVE EXHAUST VALVE
Remove using the same procedure as for the intake valve.
13711E
7.REMOVE INTAKE VALVE STEM OIL SEAL
13715A
8.REMOVE EXHAUST VALVE STEM OIL SEAL
Remove using the same procedure as for the intake valve stem oil seal.
13734A
9.REMOVE INTAKE VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the 6 valve spring seats from the cylinder head sub-assembly by blowing air onto them.
13734B
10.REMOVE EXHAUST VALVE SPRING SEAT
Remove using the same procedure as for the intake valve spring seat.
11117E
11.REMOVE NO. 1 STRAIGHT SCREW PLUG
|
|
Using a 6 mm straight hexagon wrench, remove the 3 No. 1 straight screw plugs from the cylinder head sub-assembly.
11117F
12.REMOVE NO. 2 STRAIGHT SCREW PLUG
|
|
Using a 10 mm straight hexagon wrench, remove the No. 2 straight screw plug from the cylinder head sub-assembly.
13.REMOVE STUD BOLT
|
|
Using an E8 "TORX" socket wrench, remove the 6 stud bolts.
11122
14.REMOVE INTAKE VALVE GUIDE BUSH
Heat the cylinder head sub-assembly to between 80 and 100°C (176 to 212°F).
Be sure to wear protective gloves.
Using SST and a hammer, tap out the intake valve guide bush.
11126
15.REMOVE EXHAUST VALVE GUIDE BUSH
Heat the cylinder head sub-assembly to between 80 and 100°C (176 to 212°F).
Be sure to wear protective gloves.
Using SST and a hammer, tap out the exhaust valve guide bush.
11115A
16.REMOVE RING PIN
|
|