| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder block removal/installation are shown below.
12211
1.REMOVE NO. 1 VENTILATION CASE
|
|
11432R
2.REMOVE CYLINDER BLOCK WITH HEAD STRAIGHT SCREW PLUG
Using a 10 mm hexagon socket wrench, remove the cylinder block with head straight screw plug and gasket from the cylinder.
3.REMOVE CONNECTING ROD CAP
Note the alignment marks on the connecting rod and connecting rod cap so that they can be reinstalled to their original locations.
Using an E12 "TORX" socket wrench, remove the 2 connecting rod bolts and connecting rod cap.
4.REMOVE PISTON WITH CONNECTING ROD
13041
5.REMOVE CONNECTING ROD BEARING
6.REMOVE CRANKSHAFT BEARING CAP
Uniformly loosen and remove the 8 crankshaft bearing cap set bolts.
Remove the 4 crankshaft bearing caps from the cylinder block sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
13411
7.REMOVE CRANKSHAFT
11791
8.REMOVE CRANKSHAFT THRUST WASHER
11711
9.REMOVE CRANKSHAFT BEARING
13011
10.REMOVE PISTON RING SET
| *a | Front Mark Cutout Portion | - | - |
Using a piston ring expander, remove the No. 1 compression ring and No. 2 compression ring from the piston.
Remove the oil ring expander, upper side rail and lower side rail from the piston by hand.
11.REMOVE PISTON PIN
| *a | Front Mark Cutout Portion | *b | Protective Tape |
Using a screwdriver, pry out the 2 piston pin hole snap rings from the piston.
Tape the screwdriver tip before use.
Gradually heat each piston to between 80 and 90°C (176 to 194°F).
Be sure to wear protective gloves.
Using a brass bar and a hammer, lightly tap out the piston pin and remove the connecting rod.
The piston and piston pin are a matched set.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
15708
12.REMOVE NO. 1 OIL NOZZLE SUB-ASSEMBLY
Using a 5 mm hexagon wrench, remove the 3 bolts and 3 No. 1 oil nozzle sub-assemblies from the cylinder block sub-assembly.
13.REMOVE RING PIN
|
|
14.REMOVE STRAIGHT PIN
|
|