| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | MOTOR CABLE | G1148 | ( )
|
- | - |
| 2 | TERMINAL CAP | 82823M | ( )
|
- | - |
| 3 | CONNECTOR COVER | 82821T | ( )
|
- | - |
| 4 | HYBRID MOTOR CONTROL INVERTER ASSEMBLY | G92A0 | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
G1148
1.INSTALL MOTOR CABLE
|
|
| *a | Waterproof Seal | - | - |
Using an insulated tool, install the motor cable to the hybrid vehicle transaxle assembly with the 6 bolts.
82823M
2.INSTALL TERMINAL CAP
|
|
82821T
3.INSTALL CONNECTOR COVER
|
|
Temporarily install the connector cover to the hybrid vehicle transaxle assembly with the 2 bolts.
Tighten the 2 bolts to install the connector cover.
G92A0
4.INSTALL HYBRID MOTOR CONTROL INVERTER ASSEMBLY