| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT DISC BRAKE DUST COVER | 47782 | - | - | - |
| 2 | FRONT AXLE HUB SUB-ASSEMBLY | 43502C | ( )
|
- | - |
| 3 | FRONT LOWER BALL JOINT ASSEMBLY | 43340A | ( )
|
- | - |
| 4 | FRONT AXLE ASSEMBLY | - | - | - | - |
| *1 | STEERING KNUCKLE | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
47782
1.INSTALL DISC BRAKE DUST COVER FRONT LH
43502C
2.INSTALL FRONT AXLE HUB SUB-ASSEMBLY
Secure the steering knuckle between aluminum plates in a vise.
Do not overtighten the vise.
Using a 12 mm hexagon socket wrench, install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 3 bolts.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.
4.INSTALL FRONT AXLE ASSEMBLY