| ● | Non-reusable part | - | - |
1.DRAIN HYBRID TRANSAXLE FLUID
2.REMOVE REAR DRIVE SHAFT ASSEMBLY
41309L
3.REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY LH
Using SST, remove the differential side gear shaft sub-assembly LH from the rear traction motor with transaxle assembly.
Do not damage the differential side gear shaft LH type T oil seal.
Secure the differential side gear shaft sub-assembly LH in a vise between aluminum plates.
Do not overtighten the vise.
Using 2 screwdrivers and a hammer, remove the snap ring from the differential side gear shaft sub-assembly LH.
Cover the snap ring with a piece of cloth to prevent it from flying out.
41309K
4.REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
41336M
5.REMOVE DIFFERENTIAL SIDE GEAR SHAFT DUST COVER LH
Secure the differential side gear shaft sub-assembly LH in a vise between aluminum plates.
Do not overtighten the vise.
Using a screwdriver and hammer, remove the differential side gear shaft dust cover LH from the differential side gear shaft sub-assembly LH.
Do not damage the differential side gear shaft sub-assembly LH.
41336L
6.REMOVE DIFFERENTIAL SIDE GEAR SHAFT DUST COVER RH
Perform the same procedure as for the LH side.