41309L
1.REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY LH
41309K
2.REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
41309N
3.REMOVE DIFFERENTIAL SIDE GEAR SHAFT LH TYPE T OIL SEAL
Using SST, remove the differential side gear shaft LH type T oil seal from the rear traction motor with transaxle assembly.
When removing the differential side gear shaft LH type T oil seal, make sure not to damage the rear traction motor with transaxle assembly.
41309E
4.REMOVE DIFFERENTIAL SIDE GEAR SHAFT RH TYPE T OIL SEAL
| *a | Hold |
| *b | Turn |
Using SST, remove the differential side gear shaft RH type T oil seal from the rear traction motor with transaxle assembly.
When removing the differential side gear shaft RH type T oil seal, make sure not to damage the rear traction motor with transaxle assembly.
41309N
5.INSTALL DIFFERENTIAL SIDE GEAR SHAFT LH TYPE T OIL SEAL
| *a | Depth |
Using SST and a hammer, install a new differential side gear shaft LH type T oil seal to the rear traction motor with transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Do not install the differential side gear shaft LH type T oil seal at an angle.
Do not damage the differential side gear shaft LH type T oil seal.
Coat the lip of the differential side gear shaft LH type T oil seal with a small amount of MP grease.
41309E
6.INSTALL DIFFERENTIAL SIDE GEAR SHAFT RH TYPE T OIL SEAL
| *a | Depth |
Using SST and a hammer, install a new differential side gear shaft RH type T oil seal to the rear traction motor with transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Do not install the differential side gear shaft RH type T oil seal at an angle.
Do not damage the differential side gear shaft RH type T oil seal.
Coat the lip of the differential side gear shaft RH type T oil seal with a small amount of MP grease.
41309L
7.INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY LH
41309K
8.INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY RH