Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.
1.REMOVE FRONT WHEEL
75602A
2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
53876A
3.SEPARATE FRONT FENDER LINER
| *a | Clip | *b | Screw |
| *c | Grommet | - | - |
89543
4.SEPARATE FRONT SPEED SENSOR
47313J
5.SEPARATE FRONT FLEXIBLE HOSE
89543
6.REMOVE FRONT SPEED SENSOR
Disengage the clamp from the front shock absorber assembly.
Remove the bolt and front speed sensor from the steering knuckle.
Keep the tip of the front speed sensor and installation hole free of foreign matter.
Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Rotating or applying excessive force may result in damage to the front speed sensor.