Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › 2020.08–2021.07
RM3700E _51 Engine / Hybrid System _093766 M15A-FKS ENGINE CONTROL _0442024 CRANKSHAFT POSITION SENSOR A

M15A-FKS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A459209N01
1.865,3.667 2.198,3.667 false 2.281,2.26 2.521,2.26 2.521,2.26 2.865,1.823 false 3.271,1.833 3.479,1.229 3.479,1.229 3.656,1.229 false 2.063,2.135 2.344,2.49 0.281,0.354 18 false 2 1.656,3.542 1.938,3.896 0.281,0.354 18 false 1 3.708,1.167 3.99,1.521 0.281,0.354 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 STARTER ASSEMBLY 28100 - - -
2 CRANKSHAFT POSITION SENSOR 11401G (Click here) - -

● Non-reusable part - -

PROCEDURE

Hide 28100 1.REMOVE STARTER ASSEMBLY

Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A458050N02
0.99,0.177 1.271,0.531 0.281,0.354 18 false iii 4.51,0.156 5.042,0.448 0.531,0.292 18 true i, ii

i.

Disconnect the crankshaft position sensor connector.


ii.

Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



iii.

Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.