Home › Engine / Hybrid System › M15A-FKS (STARTING) › STARTER › 2020.08–2021.07
RM3700E _51 Engine / Hybrid System _093780 M15A-FKS STARTING _0442169 STARTER A

M15A-FKS STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

A472801N01
2.406,3.667 2.823,3.667 false 1.771,1.583 2.188,1.583 false 1.521,1.083 1.938,1.083 false 2.333,0.75 2.75,0.75 false 2.563,1.354 2.979,1.354 false 3.656,0.833 4.073,0.833 false 5.448,0.667 5.865,0.667 false 6.552,0.167 6.885,0.167 false 6.5,0.583 6.833,0.583 false 6.344,0.052 6.625,0.406 0.281,0.354 18 false 1 6.333,0.448 6.615,0.802 0.281,0.354 18 false 2 5.917,0.5 6.198,0.854 0.281,0.354 18 false 4 3.469,0.667 3.75,1.021 0.281,0.354 18 false 5 1.552,1.479 1.833,1.833 0.281,0.354 18 false 6 2.833,0.583 3.115,0.938 0.281,0.354 18 false 7 3.031,1.208 3.313,1.563 0.281,0.354 18 false 7 1.323,0.948 1.604,1.302 0.281,0.354 18 false 7 2.885,3.563 3.167,3.917 0.281,0.354 18 false 3 1.302,4.115 1.583,4.469 0.281,0.354 10 false x4 1.885,4.323 2.167,4.677 0.281,0.354 10 false x4 2.396,4.115 2.677,4.469 0.281,0.354 10 false x9

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 NO. 1 ENGINE UNDER COVER ASSEMBLY 51410 - - -
4 AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE - - - -
5 WIRE HARNESS - - - -
6 FLYWHEEL HOUSING SIDE COVER 11363A - - -
7 STARTER ASSEMBLY 28100 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 51410 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

a.
A472802


Hide 5.DISCONNECT WIRE HARNESS

a.
A461629


Hide 11363A 6.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A459814


Hide 28100 7.REMOVE STARTER ASSEMBLY

a.
A461630