|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
16031
1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Install a new gasket to the water inlet with thermostat sub-assembly.
Be sure to clean the contact surfaces.
Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.
16283
2.INSTALL NO. 6 WATER BY-PASS HOSE
3.INSTALL BRACKET
Using an 8 mm socket wrench, connect the bracket to the engine water pump assembly (water inlet housing) with the bolt.
Connect the engine water pump assembly (water inlet housing) connector.
16572D
4.CONNECT NO. 2 RADIATOR HOSE
17111
5.INSTALL INTAKE MANIFOLD
6.ADD ENGINE COOLANT (for Engine)
7.INSPECT FOR COOLANT LEAK (for Engine)
51410
8.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY