Home › General › MAINTENANCE › M15A-FXE AUXILIARY BATTERY › 2020.08–2021.07
RM3700E _V1 General _093024 MAINTENANCE _0442335 M15A-FXE AUXILIARY BATTERY A

MAINTENANCE  M15A-FXE AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A479532N01
1.75,1 1.333,1 false 2.667,2.167 2.25,2.167 false 1.167,2.667 0.75,2.667 false 0.917,3.667 0.5,3.667 false 2.583,3 2.167,3 false 3.073,3.25 2.906,3.25 2.906,3.25 2.49,3.833 false 6.875,0.188 6.458,0.188 false 3.146,0.958 3.365,1.25 0.219,0.292 10 false x2 3.083,2.042 3.458,2.51 0.375,0.469 18 false 6 0.583,2.5 0.958,2.969 0.375,0.469 18 false 3 1.125,0.833 1.5,1.302 0.375,0.469 18 false 2 0.292,3.531 0.667,4 0.375,0.469 18 false 4 3.167,3.083 3.542,3.552 0.375,0.469 18 false 5 2.625,2.833 3,3.302 0.375,0.469 18 false 7 6.281,0.052 6.656,0.521 0.375,0.469 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION (Click here) - -
2 REAR UNDER SIDE COVER RH 76973F - - -
3 CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
4 BATTERY HOSE 28885B - - -
5 NO. 2 BATTERY CLAMP 74482 - - -
6 CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
7 AUXILIARY BATTERY - - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



Hide 76973F 2.REMOVE REAR UNDER SIDE COVER RH

a.
A476157


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A458013


Hide 28885B 4.REMOVE BATTERY HOSE

a.
A458014


Hide 74482 5.REMOVE NO. 2 BATTERY CLAMP

a.
A477756


Hide 6.DISCONNECT CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL

Z101186

NOTICE:

To prevent the wire harness from being pinched during installation, do not remove the clamp from the No. 2 battery clamp.



a.
A479531


Hide 7.REMOVE AUXILIARY BATTERY

a.
A458017