Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3700E _56 Audio / Visual / Telematics _093686 AUDIO / VIDEO _0442502 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATIN)
E452072N03
3.969,0.802 4.719,0.969 0.75,0.167 4.167,1.604 4.167,1.271 false 1.833,2.167 2,2.5 2,2.5 2.167,2.5 false 3.625,1.042 3.792,0.875 3.792,0.875 3.958,0.875 false 3.948,1.698 4.104,1.896 0.156,0.198 10 false ● 2.24,2.365 2.521,2.719 0.281,0.354 18 false 2 4.125,1.625 4.406,1.979 0.281,0.354 18 false 1 4.073,0.813 5.427,0.969 1.354,0.156 8 false 10 (102, 7)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 RADIO SETTING CONDENSER 86011A (Click here) - -
2 DECK TRIM SIDE PANEL ASSEMBLY LH 64740C - - -

V100146

N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part

PROCEDURE

Hide 86011A 1.INSTALL RADIO SETTING CONDENSER

a.
E452100C02
0.969,0.135 1.229,0.396 0.26,0.26 18 true i 4.635,0.125 4.896,0.385 0.26,0.26 18 true ii 3.49,3.177 3.75,3.438 0.26,0.26 18 true iii 4.188,3.063 4.448,3.323 0.26,0.26 18 true iv
V113147

Remove in this Direction - -


i.

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.




ii.

Engage the claws to install the new terminal cover with wire harness to a new radio setting condenser as shown in the illustration.

NOTICE:
·

Do not use excessive force when inserting the terminal covers into the condenser.

·

If a terminal cover has been deformed during installation, replace the terminal, terminal covers and radio setting condenser with new ones.




iii.

Engage the clamp to temporarily install the radio setting condenser with wire harness.


iv.

Install the radio setting condenser with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



Hide 64740C 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

a.

Use the same procedure as for the RH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>INSTALLATION