| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 ANTENNA CORD SUB-ASSEMBLY | 86101J | ( )
|
- | - |
| 2 | NO. 1 ROOF WIRE | 64771G | ( )
|
- | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | NO. 3 ROOF SILENCER PAD | 63343 | ( )
|
- | - |
| 4 | NO. 1 ROOF SILENCER PAD | 63341 | ( )
|
- | - |
| 5 | NO. 2 ROOF SILENCER PAD | 63342 | ( )
|
- | - |
| 6 | NO. 5 ROOF SILENCER PAD | 63345 | ( )
|
- | - |
82171
2.INSTALL NO. 1 ROOF WIRE
|
Install in this Direction | - | - |
Turn the visor connector approximately 90° clockwise to connect the visor connector.
| *a | Positioning Tape | *b | Marking |
Line up the No. 1 roof wire positioning tape and the roof headlining markings.
| *a | Adjustment Area | - | - |
Install the No. 1 roof wire with new pieces of adhesive tape.
Apply the tape securely in place.
Do not touch the adhesive surface when applying the tape to prevent adhesion failure.
Adjust the slack of the No. 1 roof wire as shown in the adjustment area of illustration.
63343
3.INSTALL NO. 3 ROOF SILENCER PAD
| *a | Marking | - | - |
Align the markings on the roof headlining with the rear roof silencer pad and install them using hot melt glue.
63341
4.INSTALL NO. 1 ROOF SILENCER PAD
| *a | Marking | - | - |
Align the markings on the roof headlining with the 3 No. 1 roof silencer pads and install them using hot melt glue.
63342
5.INSTALL NO. 2 ROOF SILENCER PAD
| *a | Marking | - | - |
Align the markings on the roof headlining with the No. 2 roof silencer pad and install them using hot melt glue.
63345
6.INSTALL NO. 5 ROOF SILENCER PAD
| *a | Marking | - | - |
Align the markings on the roof headlining with the 2 No. 5 roof silencer pads and install them using hot melt glue.