| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BACK DOOR TRIM BOARD | 67751 | - | - | - |
| 2 | POWER BACK DOOR UNIT SET ASSEMBLY | 68920 | ( )
|
- | - |
| 3 | POWER BACK DOOR SENSOR ASSEMBLY | 84280D | ( )
|
- | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
67751
1.REMOVE BACK DOOR TRIM BOARD
68920
2.REMOVE POWER BACK DOOR UNIT SET ASSEMBLY
84280D
3.REMOVE POWER BACK DOOR SENSOR ASSEMBLY
Disconnect the connector.
Remove the 4 screws.
Using a clip remover with its tip wrapped with protective tape, remove the 2 clips and power back door sensor assembly.
Disengage the claw and remove the 4 grommets.