| *A | w/ Entry and Start System | *B | w/o Entry and Start System |
| *1 | ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY | *2 | CLIP BAND |
| ● | Non-reusable part | - | - |
| *A | w/o Entry and Start System | - | - |
| *1 | UPPER STEERING COLUMN BRACKET ASSEMBLY | - | - |
Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.
If the power steering ECU assembly is subjected to an impact, replace it with a new one.
Do not pull the wire harness.
Do not allow any moisture to come into contact with the power steering ECU assembly.
Do not loosen any bolts not mentioned in the procedure.
Do not allow any foreign matter to contaminate the power steering ECU assembly.
Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
45020B
1.REMOVE STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY (w/ Entry and Start System)
| *a | Wooden Block | *b | Cloth |
|
Turn | - | - |
Secure the steering column assembly in a vise using aluminum plates, cloths and wooden blocks.
Do not overtighten the vise, as the steering column assembly may become deformed.
Secure the power steering ECU assembly so that it is upright.
Support the steering column assembly with wooden blocks or similar items to ensure that it does not fall.
Using SST, strike a punch mark for drilling in the center of the steering lock set bolt.
When striking the punch mark, in order to prevent impact force from being applied to the steering lock actuator or upper bracket assembly, do not use a normal center punch.
Using a drill, drill a hole in the 2 steering lock set bolts and insert a screw extractor.
Using the screw extractor, remove the 2 steering lock set bolts, upper steering column clamp and steering lock actuator or upper bracket assembly.
2.REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)
Use the same procedure for the steering lock actuator or upper bracket assembly.
89782
5.REMOVE TRANSPONDER KEY COIL (w/o Entry and Start System)
84052
6.REMOVE UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)
|
Insert |
|
Remove in this direction |
Insert the key.
Disengage the claws to remove the un-lock warning switch assembly as shown in the illustration.
7.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
|
Push |
|
Remove in this direction |
Turn the ignition switch to ACC.
Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and remove the ignition switch lock cylinder assembly.
84450
8.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)